My 2S board shipped with 1.1f and did not require updating. Step 1 (Optional)- Upgrade your Neje Firmware

Remember, Lightburn completely replaces your Neje software, so you will never need to open it again (although you can switch back and forth if desired).Įnsure that the laser is plugged into the PC via USB Patience - Neje has made significant improvements over the past couple years with regards to Lightburn compatibility, but expect possible troubleshooting.Ĭlose all other applications (especially any Neje programs). Earlier Master 2 machines are compatible, but require additional steps and cannot auto-home due to control board wiring.

Master 1 machines are not compatible due to their inability to accept standard GRBL Gcode. Neje Master 2S (32 bit) - This is the 3rd/4th(?) generation Neje Master that started becoming available in late 2020. To read the differences, please see this separate blog post here.Ĭaution for Mac Users: Many on Mac have been unsuccessful due to USB driver issues. There are many advantages to using Lightburn over the Neje Software. If this is the Neje you own, then this is the tutorial for you.Īdvantages of Lightburn over Neje Software Master 2S (auto-homing, 32 bit) - This is the newer, 32-bit version of the Neje Master 2. This 2S tutorial MAY work for you as this board is closer to that in this tutorial. I do not own one of these boards, so I do not have a tutorial available. Master 2 (auto-homing) - This is a newer version board of the same Master 2 16-bit Neje.

Master 2 (non-S, non-homing) - Tutorial Here - This is the older version of the Master 2 which does not support auto-homing. Master (Original) - This Neje does not support Lightburn and does not have an available tutorial. If you do not have an ‘S’ after the 2, then this is NOT the correct tutorial for you. There are multiple versions of the Neje Master. MUST READ: Verify you are on the correct tutorial! By following these instructions, you agree to take full responsibility for your health and the safety of your environment. I am merely a Neje user that wanted to use what I believe to be the best available laser software. I am associated with neither Neje nor Lightburn. My preferred alternative laser software is Lightburn. Out of the box, it performs well for simple tasks, but if you want to do more, you’re going to need to take advantage of alternative software and the Master 2s’ability to accept regular Gcode. The Neje Master 2S is a small, affordable laser engraver with a strong following.

Lightburn software 7w laser settings